NRH285DR operates from a 5Vdc (±0.5) regulated supply to each independent sensor channel, and has two independent outputs, enabling full redundancy from a very slim package.

NRH285DR  has a co-moulded fully encapsulated sensor system that can withstand high shock and vibration as well as operate up to +170°C, and endure high pressure wash-downs (IP69K).  The sensor is activated by a separate magnet in a choice of three options.

SRH500P and SRH280P Series have single or dual outputs and are contactless rotary sensors These have been specially developed to meet the harsh operating requirements in heavy duty industrial position sensing applications, including construction, agricultural, military and utility vehicles, as well as a variety of uses in steelworks, marine equipment and power generating plants. This model has an option for environmental protection to IP69K.

STT 500 and 280 Series Tilt Sensors use solid state 3D-MEMS (Micro-Electro-Mechanical Systems) technology to measure the sensor's inclination relative to earth's gravity. These electronic tilt sensors are suitable for use in applications such as road construction equipment, cranes and booms, scissor lifts, agricultural vehicles, container handling and hydraulic lift systems. By using solid-state system-on-chip technology, the STT series provides distinct advantages in reliability, stability and compactness over fluid based, electrolytic and pendulum operated sensors. For maximum flexibility this new sensor range has a low power requirement of less than 6.5mA, so it can be used in hard-wired or battery-powered wireless systems.